In most cases, the new elements must be added in the relevant add-on module first.
Image 01 shows you that the check mark for "All" is not set. Therefore, the new elements have to be added manually.
In most cases, the new elements must be added in the relevant add-on module first.
Image 01 shows you that the check mark for "All" is not set. Therefore, the new elements have to be added manually.
The Concrete Design add-on for RFEM allows you to perform the fire design of reinforced concrete walls and slabs according to the simplified table method (EN 1992‑1‑2, Section 5.4.2 and Table 5.8 and 5.9).
In the Concrete Design add-on, you have the option to define an existing vertically oriented punching shear reinforcement. This is then taken into account in the punching shear design.
In RFEM, the oriented strand board (OSB) material is available for the USA and Canada. The material parameters are taken from the "Panel Design Specification manual".
In the ultimate configuration of the steel joint design, you have the option to modify the limit plastic strain for welds.